Asko W6OO-SERIES Service Manual page 44

TENSION RING AND BALANCING SPRING
CHANGING THE TENSION RING CHANGING THE TENSION RING CHANGING THE TENSION RING CHANGING THE TENSION RING CHANGING THE TENSION RING
1. Remove the front panel (see page 32.)
2. Remove the front cover plate (see page 36).
3. Install the special tool (part no. 8801152).
Fasten the special tool's three stays in the drum
end.
4. Slacken the tension ring and remove it. Do not
pry the tension ring off. Undo one end and turn
it round the holder to remove it.
5. Install the new tension ring by turning it to the
right place and then securing the screw.
6. Tighten the screw fully. Use a rubber mallet to
knock the tension ring into place on the upper
edge. Also move it to the edge of the end plate
with pliers.
7. Tighten the tension ring more.
8. Remove the special tool.
9. Replace the cover plate.
Special tool
P/N 8801152
Tension ring
P/N 8061699
Bolt
P/N 8061116
Washer
P/N 8901335
Nut
8901154
44
CHANGING THE BALANCING SPRING CHANGING THE BALANCING SPRING CHANGING THE BALANCING SPRING
CHANGING THE BALANCING SPRING CHANGING THE BALANCING SPRING
1. Remove the top cover (see page 20).
2. Use pliers to unhook the balancing spring from
the holder.
3. Front spring: Unhook the spring from the front
rail.
Rear spring: Unhook the spring from the cross
member.
4. Install a new spring by first hooking it to the
member and then to the holder.
5. Replace the top cover. (Don't forget the two
star washers for the outermost screws.)
Balancing spring
P/N 8061923