Asko W6OO-SERIES Service Manual page 26

REAR PANEL AND DRIVE BELT
REMOVING THE REAR P REMOVING THE REAR PANEL REMOVING THE REAR P REMOVING THE REAR P REMOVING THE REAR P
1. Using a 20 torx, remove the twelve screws
around the rear panel.
2. Lift off the panel.
REPLACING THE REAR PANEL REPLACING THE REAR P REPLACING THE REAR P
REPLACING THE REAR P REPLACING THE REAR P
3. Using the two hooks on the upper edge to
assist, align the rear panel.
4. Refit the twelve screws.
Rear panel
P/N 8061737
Screws
P/N 8900338
26
ANEL ANEL ANEL ANEL
ANEL ANEL ANEL
ANEL
CHANGING THE DRIVE BEL CHANGING THE DRIVE BEL CHANGING THE DRIVE BELT T T T T CHANGING THE DRIVE BEL CHANGING THE DRIVE BEL
1. Remove the rear panel.
2. Take off the drive belt by lifting it off one side
of the pulley and turning the pulley.
3. Install a new drive belt in the reverse order. Start
by putting the belt under the motor pulley.
4. Make sure the drive belt is centered on the top
edge of the pulley. Turn the pulley to check this.
5. Replace the rear panel.
Drive belt
P/N 8061682