Asko W6OO-SERIES Service Manual page 43

CHANGING THE HEATING ELEMENT CHANGING THE HEA CHANGING THE HEA
CHANGING THE HEA CHANGING THE HEA
1. Remove the rear panel (see page 26).
2. Disconnect the wiring and unscrew the nut as
far as possible.
3. Tap the screw so that the seal on the inside is
separated from its flat washer.
4. Let the seal shrink and then pull out the element.
5. Install the element by pushing it in as far as
possible.
6. Tighten the nut and connect the wiring.
7. Replace the rear panel.
Heating element
P/N 8061706
TING ELEMENT TING ELEMENT TING ELEMENT
TING ELEMENT
HEATING ELEMENT AND THERMISTOR
CHANGING THE THERMISTOR CHANGING THE THERMISTOR
CHANGING THE THERMISTOR CHANGING THE THERMISTOR CHANGING THE THERMISTOR
1. Remove the top cover (see page 20).
2. Remove the rear panel (see page 26).
3. Remove the thermistor by pulling it out to the
left.
4. W600 and W620: Remove the thermistor
header connector from the temperature selector.
W640 and W660: Remove the thermistor header
connector from the program control board.
5. Install the new thermistor by threading it through
the hole between the cradle and holder.
6. W600 and W620: Connect the thermistor to
the temperature selector.
W640 and W660: Connect the thermistor to
the program control board.
7. Replace the rear panel.
8. Replace the top cover. (Don't forget the two
star washers for the outer screws.)
Holder
P/N 8061738
Thermistor
P/N 8061663
43