Page 1
Model W600 (WM-33) Date Page 2000-02 INDEX W600 WASHER (WM-33) PROGRAMS DETERGENT DRAWER SPARE PARTS LISTS ♦ ♦ Casing and related parts ♦ ♦ Lower section ♦ ♦ Cylinder and related parts ♦ ♦ Control panel ♦ ♦ Upper section SERVICE INFORMATION ♦...
For instructions on how to open the door manually in case of power failure, refer to the Use and Care Guide. PROGRAMS Your ASKO washer has several programs and options specifically designed to give you the cleanest laundry possible. The tables below define each program and option. The C and S on the Program Control are fault codes, which are explained on the next page.
Page 3
Model W600 (WM-33) Date Page PROGRAMS 2000-02 OPTIONS Option Definition Super Rinse – Provides two additional rinses. Recommended for persons with sensitive skin or allergies. Economy – Extends the main wash time by 22 minutes. When used with low wash temperatures (85°–100°...
2000-02 THE DETERGENT DRAWER The detergent drawer on ASKO washers automatically dispenses the detergent and fabric softener at the appropriate times. The drawer is located to the left of the control panel. Simply pull the drawer out and pour the measured amounts of detergent and softener into the proper compartments (as illustrated) and close the drawer.
Page 5
Model W600 (WM-33) Date Page 2000-02 This page intentionally blank.
Model W600 (WM-33) Date Page 2000-02 CASING AND RELATED PARTS...
Page 7
Model W600 (WM-33) Date Page 2000-02 CASING AND RELATED PARTS Description Notes Part No. 8061817-0 Top Cover, white 8900338 Screw RTK STt 4.2x9.5 FZB T20 8901413 Lock washer AZ 4.3 galv. 8064062 Strip, top cover WMD20 8801174-0 Side plate compl.
Model W600 (WM-33) Date Page 2000-02 LOWER SECTION...
Page 9
Model W600 (WM-33) Date Page 2000-02 LOWER SECTION Description Notes Part No. 8801171 Spring leg kit WM20 8055796 Rubber buffer, spring leg 8055797 Rubber buffer, spring leg 8061668 Rubber Damper, spring leg 33256445 Washer, spring leg 37x37x2 8901193 Locking nut 8 BHB galv.
Model W600 (WM-33) Date Page 2000-02 CYLINDER AND RELATED PARTS...
Page 11
Model W600 (WM-33) Date Page 2000-02 CYLINDER AND RELATED PARTS Description Notes Part No. 8061650-0 Front door compl., white WM20 8061651-0 Frame, front door, outer, white WM20 8061652-0 Frame, front door, inner, white WM20 8061685 Front glass D306x42mm, WM20 8061798...
SERVICE I N F O R M A T I O N Group: Product: Frontloaded Front door seal Number: WM 33/44/55 Date: 00-06-14 ÄO: 7782 Page: 1(1) Reference:Bo Fredriksson Service intervention for leaking front door. First verify that the door seal is not damaged or covered by lose particles. In order to increase the sealing strip pressure against the sealing surface of the container, a special O- ring (part no.
SERVICE I N F O R M A T I O N Group: Product: WM 33/44/55/66 Wiring information Number: 149 Door lock WM 33, 44, 55, 66 Date: 00-03-15 ÄO: 7301 Page: 1(1) Reference: Per Svensson A modification to door hinge article no. 8061679 has led to the following changes: 1.
This change has been implemented on units manufactured after week 13, 2000. The part number of the timer unit does not change. Timer units manufactured from week 10, 2000 or later are fitted with the new machine programme. ASKO WM 33/44 8061756 Check the label on the side of the timer unit 230V 60 Hz...
SERVICE I N F O R M A T I O N Water levels Group: Product: WM 33/44/55/66 WM 33/44/55/66 Number: 150 Date:00-03-15 ÄO: Page: 1(1) Reference: Christer Carlsson Measurement must be carried out without laundry in machine. Wool wash level approx. 16.5 litres (Wash and rinse levels are the same) Approx.
SERVICE I N F O R M A T I O N Description of fault indications Group: Product: WM 33 / 44 Number: Date: 00-03-15 WM 33/44 (Timer) ÄO: Page: 1(2) Reference: N-Å Carlsson Description of probabable cause when timer stops in position C (Check) or S (Safety) In position C, the kind of fault can be checked by yourself, see service manual, but faults in position S are often of more serious kind and requires service action.
SERVICE I N F O R M A T I O N Group: Product: WM 33 / 44 WM 33 / 44. Number: Fault tracing Date: 00-03-15 ÄO: Page: 1(2) Reference: B Haglund The machine do not start, the timer does not proceed, no filling, but control lamp indication The motor overspeeds after filling.
Page 22
SERVICE I N F O R M A T I O N Group: Product: WM 33/44 WM 33 / 44. Number: Fault tracing Date: 00-03-15 ÄO: Page: 2(2) Reference: B Haglund Do not heat. Fills water to correct level. Check with water at correct level and with supply voltage: see also 2.1-2.3 below 1.2.
Page 23
SERVICE I N F O R M A T I O N Group: Product: Wash Brushes / Grinding Stone for motor Number: 152 E Date: 00-03-15 Ceset and FHP ÄO: R-del Page: 1(1) Reference: N-Å Carlsson Brushes and Grinding Stone for motors Ceset and FHP can be ordered as specified below.
SERVICE I N F O R M A T I O N Group: Product: WM 33/44/55/66 Spring legs Number: WM 33/44/55/66 Date: 00-03-15 ÄO: 7165/7166 Page: 1(1) Reference: N-Å Carlsson Changing of spring legs has been done as below: Machines produced before week 11 1999 have spring leg nr 8061683 with a power of 27,5 + 12,5 -0 on all four legs.