Asko W6OO-SERIES Service Manual page 24

CONTROL PANEL KNOBS (W600 AND W620)
CHANGING THE KNOBS CHANGING THE KNOBS CHANGING THE KNOBS
CHANGING THE KNOBS CHANGING THE KNOBS
1. Turn the knob to the 12:00 or zero position
and pull it off. (If you use a polygrip (mole
wrench), remember to put some soft material
in the jaws so you won't scratch the plastic. Do
not pry the knob off.)
Knobs
P/N 8061892-0
2. Install the new knob by holding it in the 12:00
or zero position and pushing it into place.
CHANGING THE TEMPERATURE CHANGING THE TEMPERA CHANGING THE TEMPERA
CHANGING THE TEMPERA CHANGING THE TEMPERA
S E L E C T O R S E L E C T O R S E L E C T O R S E L E C T O R S E L E C T O R
1. Remove the top cover (see page 20).
2. Turn the knob to the 12:00 or zero position
and pull it off. (If you use a polygrip (mole
wrench), remember to put some soft material
in the jaws so as not to scratch the plastic. Do
not pry the knob off.)
3. Disconnect the terminal block.
4. Slide a thin flat-blade screwdriver through the
hole in the panel to release the snap fasteners.
5. Move the selector to the left and lift it out.
6. Install a new selector and reconnect the terminal
block.
7. Refit the knob and replace the top cover. Don't
forget the two star washers for the outer screws.
Temperature selector
P/N 8061665
24
CHANGING THE RO CHANGING THE RO CHANGING THE ROT T T T T ARY SELECT CHANGING THE RO CHANGING THE RO
1. Remove the top cover (see page 20).
2. Turn the knob to the 12:00 or zero position
3. Disconnect the terminal block.
4. Slide a thin screwdriver through the hole in the
5. Move the selector to the left and lift it out.
6. Install a new selector and reconnect the terminal
7. Refit the knob and replace the top cover. Don't
TURE TURE TURE
TURE
CHANGING THE PUSHBUTTONS CHANGING THE PUSHBUTTONS
CHANGING THE PUSHBUTTONS CHANGING THE PUSHBUTTONS CHANGING THE PUSHBUTTONS
1. Remove the control panel (see page 22).
2. The pushbuttons sit free on the pushbutton
3. Replace the control panel.
4. Check all the buttons to make sure there is no
and pull it off. (If you use a polygrip (mole
wrench), remember to put some soft material
in the jaws so you won't scratch the plastic. Do
not pry the knob off.)
panel to release the snap fasteners.
block.
forget the two star washers for the outer screws.
Rotary selector
P/N 8061728
switches. Pull off the buttons and replace them.
bind.
Pushbuttons
P/N 8061711-0
ARY SELECT OR ARY SELECT ARY SELECT ARY SELECT OR OR OR OR