Asko W6OO-SERIES Service Manual page 49

CHANGING THE CABLE ST CHANGING THE CABLE ST
CHANGING THE CABLE ST CHANGING THE CABLE ST AND CHANGING THE CABLE ST
1. Remove the top cover (see page 20).
2. Remove the wiring.
3. Route the new wiring and secure it. Make sure
that the wires are connected correctly.
4. Replace the top cover. Don't forget the two star
washers for the outermost screws.
AND AND
AND AND
Cable stand
P/N 8060956
CABLE STAND AND INLET VALVE
CHANGING THE INLET V CHANGING THE INLET VA L A L A L A L A LVE VE VE VE VE CHANGING THE INLET V
CHANGING THE INLET V CHANGING THE INLET V
1. Remove the top cover (see page 20).
2. Disconnect the water supply connection from
the inlet valve.
3. Remove the two screws under the cross member
and lift up the valve.
4. Remove the hoses and wiring.
5. Install the wiring in accordance with the
electrical schematic diagram and secure the hoses.
6. Install the inlet valve in the cross member and
secure it with the two screws. The wiring to the
lock assembly must run between the inlet valve
and the cross member.
7. Install the water supply connection.
8. Check for leaks.
9. Replace the top cover. Don't forget the two star
washers for the outermost screws.
Inlet valve
P/N 8061757
49