Asko W6OO-SERIES Service Manual page 45

REMOVING THE ELECTRICAL REMOVING THE ELECTRICAL
REMOVING THE ELECTRICAL REMOVING THE ELECTRICAL REMOVING THE ELECTRICAL
COMPONENT BRIDGE PIECE COMPONENT BRIDGE PIECE COMPONENT BRIDGE PIECE
COMPONENT BRIDGE PIECE COMPONENT BRIDGE PIECE
1. Remove the top cover (see page 20).
2. Remove the control panel (see page 22).
3. Remove the two screws at the rear from the cross
member.
4. Remove the two screws in the front rail.
5. Remove the wiring as necessary.
6. Lift out the bridge piece.
Electrical component
bridge piece
P/N 8061692
REPLACING THE ELECTRICAL REPLACING THE ELECTRICAL REPLACING THE ELECTRICAL
REPLACING THE ELECTRICAL REPLACING THE ELECTRICAL
COMPONENT BRIDGE PIECE COMPONENT BRIDGE PIECE COMPONENT BRIDGE PIECE COMPONENT BRIDGE PIECE COMPONENT BRIDGE PIECE
7. Lay the bridge piece in place.
8. Secure the two screws to the cross member and
the two to the front rail.
9. Reconnect the wiring, being careful that it is
correctly connected.
10. Replace the front panel.
11. Replace the top cover. (Don't forget the two
star washers for the outermost screws.)
ELECTRICAL COMPONENT BRIDGE PIECE AND LEVEL SWITCH
Front beam
P/N 8061690
CHANGING THE LEVEL SWITCH CHANGING THE LEVEL SWITCH CHANGING THE LEVEL SWITCH
CHANGING THE LEVEL SWITCH CHANGING THE LEVEL SWITCH
1. Remove the top cover (see page 20).
2. Squeeze the level switch securing clips, if
necessary with pliers, and remove it from the
bridge piece.
3. Remove the wiring and connector pins.
4. Remove the rubber hose from the underside.
5. Put the rubber hose onto the new level switch.
6. Connect the wiring and connector pins.
7. Insert and push the level switch to secure it on
the bridge piece.
8. Replace the top cover. Don't forget the two star
washers for the outermost screws.
Level switch
P/N 8061747
45