Wireless - Motorola NVG510 Administrator's Handbook

Link: Wireless

Wireless

When you click the link the Wireless page appears. The Wireless page displays the status of your
Wireless LAN elements.
The Wireless page's center section contains a summary of the Wireless Access Point's configuration
settings and operational status.
Field
May be either On or Off.
Wireless Operation
Network Name (SSID) This is the name or ID that is displayed to a client scan. The default SSID for the
Gateway is attxxx where xxx is the last 3 digits of the serial number located on
the side of the gateway.
May be either Enabled or Disabled . If Enabled, your SSID will not appear in a
Hide SSID
client scan.
The type of wireless encryption security in use. May be OFF-No Privacy , WPA-
Security
PSK or WEP , Default Key or Manual .
If WPA is selected, may be Both, WPA-1, or WPA-2,.
WPA Version
WEP Key Length May be 10 characters for 40/64-bit, or 26 characters for 128-bit WP encryption.
Key Here you can enter a manual encryption key.
May be 802.11b only, 802.11g only, 802.11n, or 802.11 b+g+n.
Mode
The capacity of the wireless LAN to carry traffic. May be wide or narrow .
Bandwidth
Channel The radio channel that your Wi-Fi network is broadcasting on.
Power Level May be adjusted up to 100%, lower if multiple wireless access points are in use,
and might interfere with each other.
May be either On or Off.
Wireless Protected Setup
(WPS)
The Wireless Operation function is automatically enabled by default. If you uncheck the checkbox, the Wire-
N
less Options are disabled, and the Wireless Access Point will not provide or broadcast its wireless LAN ser-
vices.
Summary Information
Status and/or Description
General Information
35