Assembly Instructions - Body Solid PowerLine PFID-130X Owner's Manual

PFID-130X
STEP 1
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
1A. attach mainframe (A) to u-base frame (F) using:
2 - (#4) M10X70mm hex head bolt
4 - (#10) M10 washer
2 - (#7) M10 nylon lock nut
1B. attach mainframe (A) to base frame (D) using:
1 - (#3) M10X65mm hex head bolt
2 - (#10) M10 washer
1 - (#7) M10 nylon lock nut
1C. insert foot caps onto ends of base frame (D) and
u-base frame (F) using:
4 - (#18) 2"X2" foot cap
1D. insert end cap into end of mainframe (A) using:
1 - (#15) 2"X2" end cap
12