Assembly Instructions - Body Solid GHYP-345 Owner's Manual

S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Base Frame (B) followed by Flate Plate (H) to
Mainframe (A) using:
2 - (#4) M12X75mm Hex Head Bolt
4 - (#10) 12mm Flat Washer
2 - (#7) M12 Nylon Lock Nut
1B. Attach Foot Frame (C) followed by Flate Plate (H) to
Mainframe (A) using:
2 - (#11) M12X80mm Hex Head Bolt
4 - (#10) 12mm Flat Washer
2 - (#7) M12 Nylon Lock Nut
1C. Insert Foot Caps into ends of Foot Frame (B) using:
2 - (#15) 75X50mm Foot Cap
1D. Insert Foot Caps into ends of Base Frame (C) using:
2 - (#13) 50X50mm Foot Cap
12