Assembly Instructions - Body Solid SAB500 Assembly Instructions And Owner's Manual

S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Base Frames (A) to Front Stabilizer (B) using:
2 - (#1) M12x75mm Carriage Bolt
2 - (#7) M12 Flat Washer
2 - (#11) M12 Nylon Lock Nut
1A. Attach Base Frames (A) to Rear Stabilizer (C) using:
2 - (#1) M12x75mm Carriage Bolt
2 - (#7) M12 Flat Washer
2 - (#11) M12 Nylon Lock Nut
10