Body Solid PowerLine PFID-130X Owner's Manual page 18

PFID-130X
STEP 4
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
4A. insert one roller rod (G) into seat frame (B) and
one roller rod (G) into leg adjuster (H).
4B. insert rollers (K) onto both ends of both roller
rods (G):
4C. insert round end caps into both ends of roller
rods (G) using:
4 - (#17) round end cap
4D. insert end caps into both ends of both back
supports (E) using:
4 - (#13) 1"X1" end cap
18