Body Solid PowerLine PFID-130X Owner's Manual page 16

PFID-130X
STEP 3
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
3A. attach both back supports (E) to back frame (C)
using:
1 - (#6) M10X145mm hex head bolt
2 - (#10) M10 washer
1 - (#7) M10 nylon lock nut
3B. insert adjuster rod (L) between both back
supports (E) and secure using:
1 - (#6) M10X145mm hex head bolt
2 - (#10) M10 washer
1 - (#7) M10 nylon lock nut
3C. attach back frame (C) to mainframe (A) using:
1 - (#5) M10X80mm hex head bolt
2 - (#10) M10 washer
1 - (#7) M10 nylon lock nut
3D. attach back pad (I) to back frame (C) using:
4 - (#1) M8X20mm hex head bolt
4 - (#8) M8 spring washer
4 - (#9) M8 washer
3E. insert end cap into end of back frame (C) using:
1 - (#16) 1"X2" end cap
16