Body Solid PowerLine PFID-130X Owner's Manual page 14

PFID-130X
STEP 2
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
2A. attach seat pad (J) to seat frame (B) using:
2 - (#1) M8X20mm hex head bolt
1 - (#2) M8X45mm hex head bolt
3 - (#8) M8 spring washer
3 - (#9) M8 washer
2B. attach seat frame (B) to mainframe (A) using:
1 - (#5) M10X80mm hex head bolt
2 - (#10) M10 washer
1 - (#7) M10 nylon lock nut
note: insert t-handle ball pin (#12) thru
mainframe (A) and seat frame (B) to adjust the
height of the seat.
2C. insert leg adjuster (H) into seat frame (B) and
secure using:
1 - (#11) quick release ring pin
1 - (#19) v-lock pin
note: v-lock pin should be pre-assembled and is used
to tighten the leg adjuster down more securley.
note: adjust seat frame (B) to highest position to
insert leg adjuster (H).
2D. insert end caps into both ends of leg adjuster (H)
using:
2 - (#14) 45mmX45mm end cap
14