Details Of Error Code Display; Major Error Codes And Troubleshooting - Hitachi DZ-GX3300E Service Manual

Troubleshooting > Display of Error Codes and Troubleshooting

4-3-2 Details of error code display

Up to eight error codes of problems can be displayed
with the dates/times when the problems occurred.
If the same problem occurs repeatedly, it will be
judged as one problem, and the same error code will
not continue to appear.
If more than eight problems occur, the error codes
will be erased beginning with the oldest problem,
and the code for the newest problem will be recorded.
If no error code is recorded, the line for error code
and problem occurrence date/time will be all zero (0).
Information:
To erase all error codes and reset to the default
status, perform system reset (remove the battery and
AC adapter/charger, and use a fi ne-tipped pen to hold
down the reset button for several seconds).

4-3-3 Major error codes and troubleshooting

Table 4-3-1 shows the error codes that are likely to frequently appear, and appropriate
troubleshooting.
If error codes other than those listed in Table 4-3-1 appear, check with the factory for
troubleshooting.
Error code Contents of problem
0200 Optical pickup failed to move.
0280
0400 Recognition of disc failed.
0401 Optical pickup was faulty.
040D No disc
1001 DVD-RW/+RW was not formatted.
1100 Reading data from disc failed.
2881 Recognition of disc failed.
3105 Recording photos failed because of
condensation in disc drive unit (optical
pickup) or dirt on optical pickup.
3122 Recording on disc failed because
it was subject to vibrations or impact
when it was being accessed.
Table 4-3-1 Major Error Codes and Troubleshooting
(*1)
4 - 13
Error Code
[Error Code] Date Time
[0400]11111405
[0401]01010905
[0000]00000000
[0000]00000000
RETURN
[0 4 0 0] 1 1 1 1 1 4 0 5
Fig. 4-3-1 Example of Error Code Display
Troubleshooting
Refer to "4-3-4 Disc load check fl owchart"
Replace the disc drive unit.
Load a disc.
Format the DVD-RW/+RW
Refer to "4-3-4 Disc load check fl owchart"
Refer to "4-3-4 Disc load check fl owchart"
Set the power switch to "OFF", and then leave the DVD
video camera/recorder in a dry place until condensation
disappears (for at least 1-2 hours).
Clean the optical pickup, referring to "4-3-5 Cleaning
disc and optical pickup".
Any vibration or impact to disc while it is being accessed
will result in no recording.
[0000]00000000
[0000]00000000
[0000]00000000
[0000]00000000
Error code
Problem occurrence
date/time
Min
Hore
Day
Month