Administering Options For The 4600 Series Ip Telephones - Avaya 4600 Series Administrator's Manual

Table 9: Impact of TLVs on System Parameter Values (continued)
System
Parameter Name
L2Q
These telephones:
do not support LLDP on the secondary Ethernet interface.
●
will not forward frames received with the 802.1AB LLDP group multicast address as the
●
destination MAC address between the Ethernet line interface and the secondary Ethernet
interface.

Administering Options for the 4600 Series IP Telephones

This chapter's Introduction
4600 Series IP Telephones. This section explains how to change parameters by means of the
DHCP or TFTP/HTTP servers. In all cases, you are setting a system parameter in the telephone
to a desired value.
those values, and a description of each one. For DHCP, the DHCP Option sets these
parameters to the desired values as discussed in
and HTTP, the parameters in
in Contents of the Upgrade Script
Avaya recommends that you administer options on the 4600 Series IP Telephones using script
files. Some DHCP applications have limits on the amount of user-specified information. The
administration required can exceed those limits, for example, for a 4630 with all applications
administered.
You might choose to completely disable the capability to enter or change option settings from
the dialpad, as of Release 1.8. As of that Release, a new system value, PROCPSWD, can be
set as part of standard DHCP/TFTP administration. If PROCPSWD is non-null and consists of 1
to 7 digits, the user cannot invoke any "dialpad options" without first pressing Mute or Hold and
entering the PROCPSWD value. See "Chapter 3" of the 4600 Series IP Telephone Installation
Guide for more information.
TLV
Name
Proprietary 802.1Q
Framing
Proprietary - PoE
Conservation TLV
indicates that there are many parameters you can administer for the
Table 10 lists the parameter names, their default values, the valid ranges for
Table 10 are set to desired values in the Script File, as discussed
on page 82.
Administering Options for the 4600 Series IP Telephones
Impact
The default L2Q is set to the value of this TLV.
No change is made to the current L2 tagging,
but the new default value is used on the next
reboot.
This proprietary TLV can initiate a power
conservation mode. The telephones that
support this will turn on/off the telephone
backlight and the backlight of an attached
EU24BL Button Module in response to this TLV.
DHCP Generic Setup on page 61. For TFTP
Issue 8 July 2008 101