Powering On The Mc9500-K; Calibrating The Screen; Replacing The Battery - Motorola MC9500-K User Manual

1 - 8 MC9500-K Mobile Computer User Guide

Powering On the MC9500-K

After the MC9500-K is connected to power the splash screen displays for about a minute as the MC9500-K
initializes its flash file system, then the calibration window appears.

Calibrating the Screen

NOTE The Calibration screen can be accessed by pressing CTRL key - BKSP key or tapping Start > Settings >
Screen > Align Screen button.
To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
Remove the stylus from its holder on the side of the MC9500-K.
1.
Carefully press and briefly hold the tip of stylus on the center of each target that appears on the screen.
2.
Repeat as the target moves around the screen, then tap the screen to continue.
3.

Replacing the Battery

To replace the battery:
Suspend the MC9500-K prior to removing the battery. Failure to properly remove the battery may cause
CAUTION
the MC9500-K to cold boot and potential loss of data.
If the MC9500-K is in suspend mode, press the red Power button to wake the device.
1.
Press the red Power button to suspend the MC9500-K.
2.
Wait for red Decode LED to turn on and then turn off.
3.
Unhook the handstrap.
4.
Press the two battery release latches to release the battery. The battery ejects slightly.
5.
Removing the Battery
Figure 1-9
Lift the battery from the MC9500-K.
6.
Insert the replacement battery, top first, into the battery compartment in the back of the MC9500-K.
7.
Press the battery down until the battery release latches snap into place.
8.
The MC9500-K powers up after inserting the battery.
Battery Latch