Operation With The Remote Control Unit; Automatic Operation; Manual Operation - Sanyo SAP-KRV96EHDS Technical & Service Manual

OPERATION WITH THE REMOTE CONTROL UNIT

1. Automatic Operation

This unit automatically switches between cooling operation and
heating operation according to the difference between the room
temperature and the temperature setting.
Check that the circuit breaker on the power panel is
NOTE
turned on.
Once mode is selected and the unit is preset by
following the steps below, you can have the air
conditioner automatically bring the room to the
desired temperature simply by pressing the ON/OFF
operation button.
STEP 1 Press the MODE selector button to
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF
operation button again.
• To change the temperature setting; press the
NOTE
temperature setting buttons and change the setting
to the desired temperature.
OI-925-9-EG
STEP 2
STEP 1
.

2. Manual Operation

STEP 4
STEP 5
Check that the circuit breaker on the power panel is
NOTE
turned on.
If the automatic operation settings of the unit do not
meet your needs, press the setting buttons as
described below and change the settings as desired.
STEP 1 Press the MODE selector button
and select the desired mode.
For heating operation
For dehumidifying operation
For cooling operation
For fan only operation
STEP 2 To start the air conditioner, press the ON/
OFF operation button.
STEP 3 Press the TEMP. setting buttons to
change the temperature setting to the
desired temperature.
Adjustable temperature range:
30 °C max.
16 °C min.
STEP 4 Set the FAN SPEED selector button to the
setting you want.
STEP 5 Press the FLAP button and set the airflow
direction as desired.
(Refer to "ADJUSTING THE AIRFLOW
DIRECTION" on page 13.)
To stop the air conditioner, press the ON/OFF
operation button again.
• Choose the best position in the room for the remote
NOTE
control unit, which also acts as the sensor for room
comfort and transmits the operating instructions.
Once you've found this best position, always keep
the remote control unit there.
• This appliance has a built-in 5-minute time delay
circuit to ensure reliable operation. When the
operation button is pressed, the compressor will
start running within three minutes. In the event of
power failure, the unit will stop.
EG
STEP 2
STEP 3
STEP 1
→
→
→
→
or 86 °F max.
60 °F min.
9