Sanyo SAP-KRV96EHDS Technical & Service Manual page 28

7-5. Removing and Installing the
Grille
Basically, these models can be installed and wired
without removing the grille. If access to any internal
part is needed, follow the steps as given below.
How to remove the grille
(1) Open the front panel until it is nearly horizontal,
grasp the sections near the front panel arms on
both sides, and then pull forward to remove the
front panel. (Fig. 9)
(2) Remove the 3 screws from the frame.
Also remove the 2 screws where the screw covers
are open. (Fig. 10)
(3) Press the 3 tabs on the top of the grille to
disengage them. (Fig. 10)
(4) Pull the grille toward you to remove it. (Fig. 10)
How to replace the grille
(1) Insert the bottom of the grille into the flap, with the
flap at a more-or-less horizontal position.
(2) While aligning both edges of the grille with the
frame, move the panel horizontally and insert the
top and bottom into the frame.
(3) Press the air discharge outlet firmly with your hand
to ensure no gap exists between the main unit and
grille.
(4) Tighten the 2 screws and close the screw covers.
Also tighten the 3 screws of the frame.
(5) Grasp the sections near the front panel arms on
both sides, hold the front panel so that it is nearly
horizontal, bring the arm shafts into contact with
the top of the grooves on the right and left sides of
the air conditioner, and then push firmly until the
arm shafts click into place. (Fig. 11)
(6) After closing the front panel, press firmly on the
parts indicated by the arrows to securely fasten the
panel in place. (Fig. 12)
NOTE
Check that no gap exists between the main unit and
grille.
Front panel
Arm
Screw
Front panel
28
Fig. 9
Grille
Screw cover
Fig. 10
Groove
Pin
Fig. 11
Fig. 12
Flap
Arm