Operation With The Remote Control Unit; Automatic Operation - Sanyo SAP-K71GH Technical & Service Manual

1. Automatic Operation

NOTE
NOTE
12
Operation with the Remote
Control Unit
STEP 1
Check that the circuit breaker on the power panel is turned on and that
the operation selector of the indoor unit is in the ON position.
Once mode is selected and the unit is preset by following the steps
below, you can have the air conditioner automatically bring the room to
the desired temperature simply by pressing the ON/OFF operation
button.
STEP 1 Press the MODE selector to
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF operation button again.
To change the temperature setting; press the TEMP. setting buttons
•
and change the setting to the desired temperature.
The indicates the upper limit and the lower limit for the
temperature setting.
Although the fan speed is set automatically, you can change the fan
•
speed by pressing the FAN SPEED selector button.
AIR CONDITIONER
SET TEMP.
C
1 HR.
TEMP.
TIMER
ON I /OFF
NIGHT
MODE ON SETBACK
FLAP OFF
FAN SPEED SET
ACL
SELECT TIMER
BATTERIES
.
STEP 2
OI-153-12EG