Names Of Parts - Sanyo SAP-KRV96EHDS Technical & Service Manual

NAMES OF PARTS

Air intakes
Air outlet
Remote control unit
Refrigerant tubes
OUTDOOR UNIT
Air outlet
NOTE
This illustration is based on the external view of a standard model.
Consequently, the shape may differ from that of the air conditioner
which you have selected.
This air conditioner consists of an indoor unit and an outdoor unit.
You can control the air conditioner with the remote control unit.
Air Intake
Air from the room is drawn into this section
and passes through air filters which remove
dust.
Air Outlet
Conditioned air is blown out of the air
conditioner through the air outlet.
Remote The wireless remote control unit controls
power ON/OFF, operation mode selection,
Control Unit
temperature, fan speed, timer setting, and air
sweeping.
Refrigerant
The indoor and outdoor units are connected
by copper tubes through which refrigerant gas
Tubes
flows.
Drain Hose
Moisture in the room condenses and drains off
through this hose.
Outdoor The outdoor unit contains the compressor, fan
motor, heat exchanger coil, and other
(Condensing)
electrical components.
Unit
4
INDOOR UNIT
Drain hose
UNIT DISPLAY AND OPERATION
BUTTON
INDOOR UNIT
IMPORTANT
Avoid using radio equipment such as mobile phone near
(within 1 m) the remote control receiver. Some radio
equipment may cause malfunction of the unit.
If the trouble happens, disconnect power and restart the air
conditioner after a few minutes.
REMOTE This section picks up infrared signals from the
remote control unit (transmitter).
CONTROL
receiver
OPERATION When the remote control cannot be used,
pressing this button with a small pointed tool
button
enables heating and cooling operation.
Each time this button is pressed, the type of
operation conducted is indicated by the
changing color of the OPERATION lamp.
Press the button and select the lamp color
that suits your preference for operation.
Cooling
operation
(green)
Do not set at the TEST for normal
CAUTION
operation.
This mode is used only when servicing the air
conditioner.
OPERATION This lamp lights when the system is in the
continuous AUTO (red or green), HEAT (red),
lamp
DRY (orange), COOL (green) and FAN
(green) mode.
The OPERATION lamp lights up red and
orange alternately when the system is
defrosting.
TIMER lamp This lamp lights when the system is being
controlled by the timer.
LED CLEAN This lamp lights during operation in the UV
anti-bacterial mode.
lamp
NOTE
• The front panel of the indoor unit operates automatically when
starting and stopping operation. The panel opens slightly when
operation starts, and closes when operation stops.
• The unit's display lamps are dimmed during operation in the
NIGHT SETBACK mode.
TEST button
OPERATION button
OPERATION lamp
REMOTE CONTROL
receiver
TIMER lamp
LED CLEAN lamp
Heating
Stop
operation
(lamp off)
(red)
OI-925-4-EG