Installing The Cpu Heat Sink - Cybernet H6 i-One Series User Manual

Installing the CPU Heat Sink

Cybernet i-One H6/H7
1. Put on the heat sink and make sure that the
six screws fit the corresponding screw
holes on the motherboard.
2. Alternate pressure while securing the Screws with
balance.
Note: Do not fix any screws until the four screws are in
their positions.
3. Secure the two screws at the opposite end
near the top edge of the bezel.
4. Connect the power cable to CPU Fan on the
Motherboard labeled CPU FAN 1 connector.
Page 15
System Assembly