Ione-H6/H7 Disassembly - Cybernet H6 i-One Series User Manual

i-One H6/H7 Disassembly
ORIENTATION: Presumes the top of the iOne is away from you and the bottom or I/O
controller board is nearest you.
1. Place the iOne face down on a padded surface.
2. Remove the four screws from the base plate that attaches the stand to the LCD
supporting the base while removing the last screw.
3. Remove the ten back bezel screws.
4. Carefully remove the back bezel and set aside.
5. Then remove the metal EMI shield by first removing the I/O cover by removing the
three screws on the bottom and two screws on the face. Lift the plate out and up
and set aside.
6. Remove the remaining eleven screws around the metal shield covering the
motherboard.
7. First lift the metal shield and slide it to the right clearing the optical drive door (at
the top right) then disconnect the system fan cable connector from the
motherboard at System FAN1 connector at bottom left corner next to the com port.
And System Fan2 connector at bottom right corner next to the LVDS connector.
Cybernet i-One H6/H7
Page 12
System Assembly