Omron V670-H11 User Manual page 18

2-1 Controller
No. Name
(1) Note number setup switch
(2) Dip switch
(3) LED display
RUN
COMM
NORM/ERR
RST/IN
OUT1
OUT2
(4) Cover
(5) Connecting port for pro-
gramming console
(6) Connecting port for antenna
(7) RS-232C port
(8) Power supply terminal
24 VDC+
24 VDC-
GR
(9) Input terminal
RST/IN
(10) Output terminal
OUT1
OUT2
O.COM
2-2
Function
Sets a controller node
number.
Sets every mode.
An operation status is shown on this LED displayed.
Green Shows the RUN sta-
tus.
Green Shows an operation
status.
Green Shows the end of
communication.
Red Shows an error.
Green Shows an input status.
Green Shows an output status.
Green Shows an output status.
Cover common to (1), (2) and (5).
Used to connect a
programming con-
sole.
Used to connect an
antenna.
Used to connect a
host device.
Terminal for power supply.
Supplies the power.
Terminal for input.
Supplies a reset sig-
nal or trigger signal.
Terminal for output.
Output signal 1
Output signal 2
Output common
Description
Used to identify the controllers when a maximum of 31
controllers are connected to one host computer.
Sets an input function, operation mode, protocol, com-
munication conditions, etc.
Turns on when an operation is normal.
Turns on during the communication to a tag.
Turns on once and turns off when the communication has
ended correctly.
Turns on once and turns off when the communication has
ended due to an error. Turns on when a system error
occurs.
Turns on when the RST/IN input signal turns ON.
Turns on when the OUT1 output signal turns ON.
Turns on when the OUT2 output signal turns ON.
Open as necessary.
Our programming console type C200H-PRO27 (unbundled)
can connect to this port through the connecting cable model
V700-P10 (unbundled). When you operate the programming
console, use the key sheet that comes with the V700-P10.
One antenna can connect to this port. To extend the
cable, use model V670-A4
Based on the RS-232C, a general-purpose programma-
ble controller (PLC) and PC can connect to this port.
Connects the "+" side of 24 VDC power supply.
Connects 0 V.
Ground Class D (Class III).
When external reset input and external trigger input are
used, they connects to this terminal together with 24
VDC- in pairs. Function can be selected with a dip
switch.
When external output is used, it connects to this terminal
together with O.COM in pairs.
unbundled).