Table of Contents
Advertisement
7-5-6-3 Writing
In this screen, you can write any data into any address of the tag. The same data is written into all the specified areas.
7-5-6-4 Writing Again
When you press the
key again after writing a data into the tag, you can write the data into the tag again according to the specified
start address and end address. When you press the
one. Then, the data is written into the tag again.
When you use the available designation range, check the tag memory capacity.
Set the start address to 10h, the end address to
1Fh and a data to 7F.
When you press the
key, the data is writ-
ten into the tag. When the data has been writ-
ten correctly, "OK" is shown.
or
key, the start address value and end address value increase or decrease
Set the start address to 10h, the end address to
1Fh and a data to 7F.
When you press the
key, the data is writ-
ten into the tag. When the data has been writ-
ten correctly, "OK" is shown.
When you press the
key, the data is writ-
ten into the tag again.
When you press the
key, the start address
value and end address value increase one and
the data is written into the tag again.
When you press the
key, the start address
value and end address value decrease one and
the data is written into the tag again.
Correct Data
7-5 Functions
7-15
Advertisement
Table of Contents
