Table of Contents
Advertisement
7-5 Functions
7-5-4 Address Setting
In this screen, you can specify the first address and end address, from which a data is read, to which a data is written and to be tested.
7-5-4-1 For Reading
An example to set the start address to 5Ah and the end address to 6Fh is shown below.
7-5-4-2 For Writing
An example to set the start address to 5Ah and the end address to 6Fh is shown below.
• The start address value must be equal to the end address value or less.
• When you use the available designation range, check the tag memory capacity.
7-12
You can select the start address and end
address with
When you press
accept the address input. The available charac-
ters are
The start address value must be equal to the
end address value or less. If the start address
value is more than the end address value, an
address error occurs during the communication.
Also, if the address value more than 7Fh is
specified, an address error occurs.
You can select the start address and end
address with
When you press
accept the address input. The available charac-
ters are
The start address value must be equal to the
end address value or less. If the start address
value is more than the end address value, an
address error occurs during the communication.
Also, if the address value more than 7Fh is
specified, an address error occurs.
Correct Usage
and
.
, the screen is ready to
to
and
to
.
and
.
, the screen is ready to
to
and
to
.
Advertisement
Table of Contents
