02
Note
The timing belt must most definitely be replaced if any
shortcomings are found. This will help prevent any fail-
ures or operational problems. Replacing the timing belt is
a repair measure.
Replacing toothed belt and guide pulley
for camshaft drive (1.9 SDI engines)
–
Removing and installing the toothed belt
⇒ Rep. Gr. 13; 1.9/47 SDI engine, Mechanics.
Inspecting engine oil level
When inspecting, pay attention to the following points:
Before inspecting, warm up the engine to normal temper-
ature.
Wait at least 3 minutes after switching off the engine to al-
low the oil to flow back into the oil pan.
–
Withdraw dipstick, wipe off with a clean cloth and re-
insert dipstick fully.
–
Withdraw dipstick once again and read off oil level.
Fig. 1:
Oil dipstick version I
Fig. 2:
Oil dipstick version ll
The oil level in area -a-
–
The oil must be topped up. It is sufficient when the oil
level rises to the area -b-.
The oil level in area -b-
–
The oil can be topped up. It is possible that the oil level
will rise to the area -c-.
The oil level in area -c-
–
The oil must not be topped up.
Note
♦
The oil level must not, under any circumstances, be
above area -a- - danger of damage to the catalytic
converter.
♦
The vehicle must be standing on level ground when
measuring the oil level. Wait a few minutes after
switching off the engine to allow the oil to flow back
into the oil pan.
Change engine oil
Note
♦
The engine oil should always be changed, if possible,
when the engine is at normal operating temperature.
♦
If the engine oil is drained, replace the seal of the oil
drain plug.
02-3
8
page
FABIA 2000
Engines
Inspection and Maintenance
Edition 09.04
S00.5301.14.20