FABIA 2000
Inspection and Maintenance
Oil Change Service every 15.000 km
An Oil Change Service need only be carried out if the vehicle has covered 15 000 km before one year has
1)
elapsed
. If the Oil Change Service is due only a few months prior to the Annual Inspection, it is recommend-
ed to carry out the Annual Inspection at the same time.
Work involved
–
Change engine oil
–
Replace engine oil filter
–
Disc brake pads: Inspect thickness
–
Reset service interval display
–
Drain away water from the fuel filter (diesel engine with fuel operation, which does not
comply with DIN EN 590-standard)
After each oil change
–
Complete „Next service date" sticker (max. 1 year or 15 000 km) and affix sticker to the
side of the dash panel (on the driver's side)
–
Complete and attach service mirror tag to the interior rear-view mirror
–
Hand customer the completed and signed form
Annual Inspection (every 12 months) (QG0)
♦
For vehicles with a high mileage carry out an Oil Change Service no later than after 15
1)
000 km
. Carry out Annual Inspection after 30 000 km prior to the scheduled date
♦
Every 2 years - in addition change brake fluid
♦
Every 4 years - in addition, change air filter element and clean air filter housing - vehicles
driven less than 60 000 km within 4 years - replace contents set for tyre repair
♦
Every 5 years - replace the emergency battery for the alarm
♦
Exhaust-emission analysis (EEA): Expiry date - see EEA tag on the vehicle identification
plate (only valid for some countries)
♦
Recommendation: Replace windscreen wiper blades every 2 years
♦
At each inspection - check the 'use by date' of the first aid kit
Work involved
–
Interrogate fault memory of all systems, if necessary erase
–
Inspect engine and components in the engine compartment for leaks and damage
–
Change engine oil
–
Replace engine oil filter
–
Airbag units: Perform visual inspection for external damage
–
Reset service interval display
–
Inspecting brake system for leaks and damage
–
Check the thickness of the brake pads on all wheels
–
Check gearbox, final drive, drive shafts and joint boots for leaks and damage
–
Axle joints: Inspect boots for leaks and damage
1)
The 7500 km interval applies for diesel operation with high sulphur content - it does not apply for the Czech Republic (for further information
refer to Technical Service Handbook)
Edition 09.04
S00.5301.14.20
1)
(QG0)
Inspection
02
Chapter
02-3
02-5
02-6
Chapter
02-3
02-5
02-3
02-6
02-6
02-3
02-3
02-7
02-6
02-5
02-5
02-2
5
page