Using The Remote Control Unit - DeLonghi PAC WE 110 Instructions For Use Manual

USING THE REMOTE CONTROL
• Point the remote control at the receiver on
the appliance. The remote control must be
no more than 23 ft (7 meters) away from the
appliance (without obstacles between the re-
mote control and the receiver).
• The remote control must be handled with
extreme care. Do not drop it or expose it to
direct sunlight or sources of heat.
MAX. 23 ft (7 meters)
Inserting or replacing the batteries
• Remove the cover on the rear of the remote
control (fig. 25);
• Insert two "AAA" 1.5V batteries in the correct
position (see instructions inside the battery
compartment);
• Replace the cover.
If the remote control unit is replaced or di-
sposed of, the batteries must be removed
and discarded in accordance with current
legislation as they are harmful to the envi-
ronment.
25
Setting the time
After inserting the batteries, the clock on the di-
splay flashes until the time is set.
Proceed as follows.
• Press the or button until the correct
time is reached.
Hold the button down to run rapidly through
first the minutes, then the tens of minutes.
• Once the correct time has been reached, re-
lease the button and press the OK button to
confirm.
• To cancel the settings programmed on the
remote control and restore the original set-
tings, press the
point of a pencil or pen.

USING THE REMOTE CONTROL UNIT

The first part of the controls on the remote con-
trol are the same as those on the control panel of
the appliance (fig. 26).
You should therefore refer to the instructions in
the chapter OPERATING FROM THE CONTROL
PANEL to
• turn the appliance on or off and
• select the operating mode (air conditioning,
dehumidifying, fan or Smart) and the fan
speed.
• set the required temperature.
The following section describes the additional
functions corresponding to the controls on the
bottom part of the remote control.
26
12
button lightly with the