DeLonghi PAC WE 110 Instructions For Use Manual page 8

13
1
14
2
15
Replace the cap correctly and close the tank, pu-
shing it in as far as it will go. The tank hole has a
mesh filter to prevent the introduction of foreign
matter. If necessary, this filter can be unscrewed
and removed for cleaning under running water.
• The tank does not have to be full to use the
water function, but the length of time the
appliance will operate in water mode will be
shorter.
• Do not fill above the level of the hole to avoid
the water overflowing. The tank has no over-
flow prevention system.
Replacing the limescale filter
Turn the appliance off and unplug it from the
outlet.
Make sure there is no water in the appliance by
emptying the tank and internal tray as described
in the section: "End of season operations".
Lay the appliance on its back as shown in figure
17. Rest it on a towel or piece of cardboard to
avoid scratches or damage. Remove the filter co-
ver by unscrewing the four screws (fig. 17).
Remove the filter delicately and loosen the two
ties, making sure the two hoses connecting the
filter do not slip inside the appliance. Fit the new
filter (fig.19), following the same procedure
in reverse (fig. 17-18). The notch on the filter
(see figure 16) indicates the correct direction.
The notch must always be towards the inside of
the appliance and point "A" must be facing up-
wards.
16
Water may leak out while replacing the
limescale filter. You should therefore perform
the operation in a suitable location.
After replacing the filter, wait at least an hour
before starting the machine again.
When the filter has been replaced, turn the
alarm off by pressing the ON/STAND-BY
button (15) for 10 seconds.
The appliance emits a beep.
8