Using The Remote Control Unit - DeLonghi W SERIES Instruction Manual

I
NSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control (fig. 24);
• Insert two R03 "AAA" 1.5V batteries, making sure they are in
the correct position (see the instructions inside the battery
compartment);
• Replace the cover.

If the remote control unit is replaced or discarded, the bat-
teries must be removed and disposed of in accordance
with current legislation as they are harmful to the environ-
ment.
S
ETTING THE TIME
After having inserted the batteries, the clock on the display flashes until the time is set.
Proceed as follows.
• Press the or
rapidly through first the minutes, then the tens of minutes.
• Once the correct time has been reached, release the button and press the SET button to
confirm.
• To cancel the settings programmed on the remote control and restore the original settings,
press the RESET button lightly with the point of a pencil or pen.

USING THE REMOTE CONTROL UNIT

The first part of the controls on the
remote control are the same as those
on the control panel of the appliance
(fig. 25).
You should therefore refer to the
instructions in the chapter Operating
the appliance from the control panel
to:
- turn the appliance on
- select the operating mode (AIR
CONDITIONING, DEHUMIDIFYING,
FAN, HEATING or SMART) and the
fan speed.
- set the required temperature
The following section describes the additional functions corre-
sponding to the controls on the bottom part of the remote con-
trol.
B
OOST FUNCTION
Ideal for the summer to cool rooms rapidly.
Activate by simply pressing the
The appliance operates in air conditioning mode at maximum
fan speed. While this function is selected, it is not possible to set
the temperature or change fan speed.
S
ELECTING THE TEMPERATURE SCALE
Press the button to switch the temperature display from °C
to °F and vice versa.
button until the correct time is reached. Hold the button down to run
( . 26)
FIG
button.
( . 27)
FIG
25
33 33
24
26
27