Using The Remote Control Unit; Description Of The Remote Control - DeLonghi PAC AN140HPECB Instructions For Use Manual

Using the remote control unit

DESCRIPTION OF THE REMOTE CONTROL

22) "ON/OFF" button
23) Increase/decrease button for
temperature/programmed use
24) "MODE" button
25) "TIMER" button
26) °F/°C switching button
27) Fan speed button (MAX/MED/MIN)
Replacing the batteries
• Remove the cover on the back of the
remote control;
• Insert two new LR03 "AAA" 1.5V batteries,
making sure they are in the correct posi-
tion (see the instructions inside the battery
compartment);
• Replace the cover.
If the remote control unit is replaced or discarded, the batteries must be removed and
disposed of in accordance with current legislation as they are harmful to the environment.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in fire. Batteries may explode or leak.
If the remote control will not be used for a certain length of time, remove the batteries.
• Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
• This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
• This Class B digital apparatus complies with Canadian CAN ICES-3 (B) / NMB-3 (B).
TURNING THE APPLIANCE ON
Plug the appliance into the electrical receptacle.
Press the ON/OFF button of the remote control (22) (when turned on, the air conditioner starts
operating in the same mode as when last turned off).
Press the MODE button (24) button to select the required mode:
AIR CONDITIONING (COOLING)
DEHUMIDIFYING
HEATING
FAN ONLY
The light corresponding to the selected mode lights up on the control panel.
For air conditioning/dehumidifying/heating/fan only settings and programming the timer, see the
paragraphs on pages 9 - 11.
12
27
22
23
24
25
26