SELf-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
If ... IS DISPLAYED,
Low Temperature
(frost prevention)
High Level
(internal tray full)
Change filter
If ... IS DISPLAYED,
Probe failure
(sensor damaged)
failure1
The appliance is fitted with a frost protection device to avoid excessive formation
of ice. The appliance starts up again automatically when the defrosting process is
completed.
Empty the internal safety tank following the instructions in the section "End of season
operations". If it reoccurs, contact your local authorized service center.
When this message is displayed, the water filter needs replacing as described in the
section: "Replacing the limescale filter".
If this is displayed, contact your local authorized service center.
When the F1 alarm is active, the appliance continues functioning normally in air-air
mode.
To reset the alarm, unplug the appliance then plug in again.
If the alarm reoccurs frequently, contact customer services.
...WHAT SHOULD I DO?
...WHAT SHOULD I DO?
15