Lexmark MX310 Series Service Manual page 68

Error code Description
244.06 Failed to feed from tray. Paper present sensing
supported and indicates media still in tray.
244.07 Option tray 4 pass thru sensor never became
uncovered when feeding a sheet from an option
below.
244.09 Tray 4 pick motor lost encoder.
244.11 Autocomp Pick / Lift Motor - Encoder Never Detected
in tray 4.
244.12 Motor ramp up error in tray 4.
244.13 Page to be stapled failed to feed from tray.
244.14 Sheets flushed from paper path either due to feed
error or cartridge error.
244.15 One or more trays located above the source tray 4 has
been pulled.
244.16 The engine timed out waiting for the tray 4 to report
'ready' before the 1st pick attempt.
244.17 Page was not properly picked from tray 4. Have not
exhausted all pick retry attempts as there are sheets
committed to the paper path from below.
244.19 Tray 4 fail to feed error. Detected while trying to pick
a sheet, and that leading edge was not detected by
tray sensor.
244.20 Took too long to ramp up dc feed motor in tray 4.
244.21 Pick motor stall in tray 4.
244.22 Tray 4 pick motor underspeed.
244.24 DC Feed autocompensator stalled on the last pick
attempt in tray 4.
244.32 Tray not ready.
244.33 Pick received but detected a tray pulled.
244.41 Motor 1 (Pick/Lift) Elevator motor stalled.
244.42 Motor 1 (Pick/Lift) Elevator motor PWM overflow
error (underspeed). Motor underspeed (max PWM
and motor underspeed, typical accordion jam).
244.43 Motor 1 (Pick/Lift) motor ramp (end ramp - did not
reach speed, typical pack feed paper jam).
Action
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Diagnostic information
68
7015
70.
70.
70.
70.
70.