3
Turn the printer on its side (left side down), then remove the three screws (A) from the left guide.
4
Remove the left guide.
Installation note: When re‑installing the guide, insert the spring as shown.
Right guide
1
Remove the rear cover. See
2
Remove the right cover. See
3
Remove the controller board shield. See
4
Disconnect the option cable (JOPT1) from the controller board.
5
Turn the printer on its side (right side down), then remove the three screws (B) from the right guide.
6
Remove the guide from the frame.
A
"Rear cover removal" on page
"Right cover removal" on page
"Controller board shield removal" on page
Repair information
299
302.
226.
B
7015
234.