2N EntryCom User And Service Manual page 19

Explanatory Notes to the Table Above:
For the purpose hereof, indoor environment means:
• Interior space with low relative humidity, such as corridors, offices and other
environmentally controlled rooms.
• Interior space where moisture condenses on walls but in no case flows down
the walls, such as verandas, storing rooms, industrial facilities.
• Exterior space sheltered against rain and water flowing down the walls, such
as shelters, passageways.
For the purpose hereof, outdoor environment means:
Environment, where a product is exposed to rain and / or water flowing down the
walls, such as fences, external walls of buildings, etc.
The warranty does not cover failures and defects of the product arising as
a result of improper installation (in conflict with these instructions). In
addition, the manufacturer shall not be held liable for damage incurred
through misappropriation from rooms that are accessible after the attached
electric lock is activated. The product is not intended as an anti theft / entry
device on its own only in combination with a classic safety lock.
Wall Mounting
1. Drill holes using
inserted in the manual. Use the wall
dowels attached.
2. With multiple module sets, connect the
frames as shown in the figure. Place
the basic unit on the left and extender
units on the right. The interconnecting
cable should be installed later!
3. Put the blanking modules on the
unused side holes as shown in the
figure.
4. If you are utilising a roof module, you
should install it now.
5. Screw EntryCom onto the wall. Carry the supply
cables (line, lock, power supply) through one of
the holes into the basic unit frame.
6. If you use a roof module, fix its upper and side
edges to the wall using silicone as shown in the
figure.
WARNING:
the
template,
19
Silicone