Display Installation - Barco MDCG-5121 User Manual

3. DISPLAY INSTALLATION

Prior to installing your Coronis 5MP and connecting all necessary cables, make sure to
have a suitable display controller physically installed in your computer. If you are using
a Barco display controller, please consult the user guide delivered with it to do this.
3.1 Mounting the displays
W
ARNING
mounted on its stand.
To change from landscape to portrait or the other way around, remove the panel from
its stand and use the appropriate mounting hooks as described above.
Using the single tilt & swivel foot (portrait orientation)
1. Unpack the single tilt & swivel foot and place it on a solid surface.
2. Unpack the display.
2
3. Hook the top gaps in the rear of the panel over the top anchors of the stand attachment plate (1).
4. Push the bottom of the panel firmly towards the stand so that the bottom anchors clip in the bottom
gaps (2).
5. Check that the panel is firmly attached to the stand.
6. Tilt and swivel the panel to the desired position and angle.
B4100592 CORONIS 5MP 05/08/2014
:
Do not change the display orientation by turning the panel when it is
1
3. Display installation
3
7