System - Hitachi HV-HD201 Operation Manual

4) WHITE GATE : When WHITE GATE is ON, a detection gate is displayed dimly in white on the screen.
• ON : In real time auto white balance operation or execution of memory auto white balance, a
video signal appearing in the window on screen is detected for white balancing.
In the MENU mode, the window is presented over the video signal. In the DIRECT mode,
the window is not displayed but white balance control is conducted by the white gate
function.
• OFF : A video signal of the entire image is detected for carrying out white balance control.
5) GATE AREA H : Setting of detection width of horizontal.
WHITE GATE : ON and the detection gate are displayed, and set.
• Width of setting : 0 to 10
6) GATE AREA V : Setting of detection width of vertical.
WHITE GATE : ON and the detection gate are displayed, and set.
• Width of setting : 0 to 7
7) INITIALIZE : The setting value of a AUTO WHITE menu is initialized.
Returns level menu settings to preset values. Simultaneously press L and R for about 2 seconds.

15. SYSTEM

Is settings of image output mode, an external synchronization, and camera control communication.
1) ANALOG OUT SEL： ： ： ： Analog signal output mode is set.
HD TV : Outputs the analog output signal in HDTV mode.
（Only RGB/YPbPr signal is effective. In this mode
signal is not outputted from VIDEO and VBS terminal.
SD TV : Outputs the analog output signal in SDTV mode.
SDTV picture signal is outputted from VIDEO, VBS
terminal through multi connector other than
RGB/YPbPr signal.
2) RGB/YPbPr : Output mode changeover.
• RGB ：The R, G and B video signals are output to the
MULTI connector.
• Y PB PR ：The Y Pb Pr (Y, R-Y and B-Y) signals are output to the
MULTI connector.
3) OUTPUT SYNC : The sync signal outputted from MULTI connector 13 pin is chosen.
(When the SW of camera's rear panel is set to OUTPUT)
• SYNC ：The SYNC signal is output as on external sync signal.
• HD ：The HD signal is output as an external sync signal.
(VD signal is outputted from MULTI connector 14 pin.)
4) H PHASE : Adjustment of horizontal synchronization phase.
The allowable setting range is -128 to 127.
Note: An external synchronization is not performed if the external synchronization signal corresponding to
Television System is not inputted. External synchronization for SDTV signal can not be done.
40
SYSTEM
ANALOG OUT SEL:HD TV
RGB/Y PB PR :RGB
OUTPUT SYNC :SYNC
H PHASE : 0
GL IN :75 OHM
REMOTE : 9600 BPS
MESSAGE RTN :ON
39