Table of Contents
Advertisement
5) GL IN : Impedance changeover of input to the GL IN connector.
• HIGH : The high impedance level is provided.
• 75Ω
: An impedance of 75 ohms is provided.
Note: When power to the camera is turned off, the high impedance level is provided. So, do not use this
function in a system where power is turned off for the camera unit only.
6) REMOTE : Set the remote control baud rate.
9600bps or 19200bps. (RC-Z3 allows 9600bps only.)
Note: A setup cannot be changed in the remote state, please remove a cable from a REMOTE connector.
7) MESSAGE RTN : Message display ON/OFF
• ON
: A message indicating the result of AWB/ABB execution in the DIRECT mode is displayed.
• OFF
: A message indicating the result of AWB/ABB execution in the DIRECT mode is not displayed.
16. ID/TITLE
ID and title display position and data setting menu.
1) ID : ID display position setting
Once an ID is assigned, it becomes possible to control a particular
camera unit remotely from a personal computer according to its ID.
That is, multiple camera units can be remote-controlled
individually from one persona computer.
At this function item, specify whether the ID is displayed on screen
or not. In case that the ID is displayed on screen, specify its display
position also.
• OFF
: Not displayed.
• TOP
: Displayed at the upper right corner
of screen.
• BOTTOM : Displayed at the lower right
corner of screen.
2) TITLE : At this function item, specify whether the TITLE is
displayed on screen or not.
displayed on screen, specify its display position also.
• OFF
: Not displayed.
• TOP
: Displayed at the upper left corner of screen.
• BOTTOM : Displayed at the lower left corner of screen.
42
In case that the TITLE is
ID/TITLE
ID
:OFF
TITLE
:OFF
DATA SET
:NEXT [PUSH R]
TO P TITLE
TOP ID
BOTTOM TITLE
BOTTOM ID
ID/TITLE Display Position
41
Advertisement
Table of Contents
