Executing User Program Effects; Deleting All User Program Effects - Sony DFS-700 Service Manual

User Program Effects

Executing User Program Effects

You execute a user program effect in the same way as a built-in effect, by
entering the pattern number.
Transitions between the key frames in user program effect are smooth
because spline interpolation is used to generate intermediate effects. You
can control the smoothness of transitions by adjusting the spline curve.
To execute a user program effect, use the following procedure. Except for
step 4, the procedure is the same as for executing a built-in effect by
specifying the pattern number.
1
EDITOR LUM
4
GPI CRK
SET UP MASK
SHIFT CCR
AUXILIARY
BLACK 1
BACKGROUND
BLACK 1
1
FOREGROUND
1
BLACK
1
Select the background and foreground images.
2
Press the SET button.
3
In the pattern/numeric keypad, enter the user program effect number
with buttons 0 to 9 and press ENTER.
The STATUS display window shows the number of key frames in the
effect.
4
If necessary, use F1 button and F2 knob to adjust the smoothness of
the transition.
5
Set the duration and direction of the transition as required.
6
Execute the effect with the fader lever or AUTO TRANS button.
4-18
Chapter 4 Advanced Operations
STATUS display window
USER PGM SNAP SHOT
TITLE DSK EDGE
2
STATUS EDIT
LUM LUM TRAIL
SHADOW
CRK BORDER BEVELD
EDGE INITIAL EDIT LEARN
MASK MASK SOFT
RECALL
2
LIGHTING MATTES BORDER PATTERN PAGE F1 F2 F3 F4 F5 LOCATION
HOLD
ADJ INPUT
EFFECT
TRANS RATE DSK PATTERN NUMBER
FTB
SET SET
5
CCR TITLE 1 TITLE 2 DSK SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT
N/R REV DIRECT DIRECT DSK PVW
SOURCE SOURCE FILL RECALL PATTERN
FADE
LAST X
TO
7 8 9
2 3 4 5 6 7 8 MEMORY INT TITLE INS BLACK 3,5
VIDEO
4 5 6
DEL
INT
2 3 4 5 6 7 8 MEMORY CUT
VIDEO
P IN P
DSK
1 2 3
RST
DOWN UP ENTER
0
AUTO
2 3 4 5 6 7 8 INT
MEMORY
VIDEO TRANS
PATTERN/KEY PAD
6

Deleting All User Program Effects

To delete all user program effects, use the following procedure.
1
Press the SET UP button.
The setup menu appears.
2
Press the PAGE button, to display page 6/8.
3
Press the F4(USRPGM) button, to set it to "ON".
4
Press the F5(EXEC) button.
A confirmation message appears.
5
To go ahead and delete all user program effects, press F3(OK); to
cancel press F5(CANCEL).
When you press F3, all of the saved user program effects are deleted.
4-19
Chapter 4 Advanced Operations