Adjusting Color Mattes - Sony DFS-700 Service Manual

Executing an Effect
Checking the direction and state of progress of the transition
Whether you are carrying out the effect manually or automatically, the
transition indicator on the left of the fader lever (20 LEDs) shows the state
of progress of the transition.
When you start the transition, the indicator lights progressively in the
direction of the transition, and goes off when the transition completes.
If you pause the transition, the indicator remains on in the corresponding
position.
You can always complete a paused transition by moving the fader lever in
the direction of the unlit indicator segments.
Direction of progress of
transition
3-56
Chapter 3 Basic Operation
Direction of moving
fader lever
Transition indicator
Of the 20 LEDs, ten are lit, showing that the
transition is one-half completed.

Adjusting Color Mattes

You can adjust the color of each color matte individually, and also copy
parameters from other color mattes.
Procedure
To adjust a color matte, use the following procedure.
EDITOR
GPI
SET UP
SHIFT
AUXILIARY
BLACK
BACKGROUND
BLACK
FOREGROUND
BLACK
1
Press the MATTES button in the menu control section, to display page
1 of the MATTE menu.
MATTE
1/2
PAGE
2
Press the F1(SELECT) button, to select the color matte to adjust.
INT V (internal video): color matte used for foreground and
background images
BORD (border): color matte used to fill the border applied to an
effect pattern, and as key fill for a title key
EFFECT: general-purpose color matte for use in effects
SHADOW: color matte used for shadows around an input image (fill)
DSKFL (DSK fill): color matte used as key fill for a downstream key
DSKBD (DSK border): color matte used for a downstream key border
FTB: color matte used in place of black in the fade-to-black function
3
Turn the F2(Lum), F3(Sat), and F4(Hue) knobs, to adjust the
luminance, saturation, and hue.
Note
If you vary the luminance of a color matte signal with high saturation,
the saturation is automatically adjusted so as not to go outside the
signal specifications.
1 2 3
USER PGM SNAP SHOT
TITLE DSK EDGE
1 2
STATUS EDIT
LUM LUM LUM TRAIL
SHADOW
CRK CRK BORDER BEVELD
EDGE
INITIAL EDIT LEARN
MASK MASK MASK SOFT
RECALL
CCR LIGHTING MATTES BORDER PATTERN PAGE F1 F2 F3 F4 F5 LOCATION
HOLD
ADJ INPUT
EFFECT
TRANS RATE DSK PATTERN NUMBER
FTB
SET SET
CCR TITLE 1 TITLE 2 DSK SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT N/R REV DIRECT DIRECT DSK PVW
SOURCE SOURCE FILL RECALL PATTERN
FADE
LAST X
TO
7 8 9
1 2 3 4 5 6 7 8 MEMORY INT TITLE INS BLACK
VIDEO
4 5 6
DEL
INT
1 2 3 4 5 6 7 8 MEMORY CUT
VIDEO
P IN P
DSK
1 2 3
RST
DOWN UP ENTER
0
AUTO
INT
1 2 3 4 5 6 7 8 MEMORY
VIDEO TRANS
PATTERN/KEY PAD
SELECT Lum Sat Hue CH2BRD
INT V 0-100 0-100 0-99 BRDMAT
F1 F2 F3 F4 F5
3-57
Chapter 3 Basic Operation