Table of Contents
Advertisement
Input/Output Signals
1. Input signal
(1) Genlock input
VBS 1.0 Vp-p
HD/VD TTL level (TRIG connector)
(2) Serial data (4 pin connector)
1.5 Vp-p
RS-232C level (in connection with personal computer)
(Note)
Set internal switch according to connected equipment.
(3)
Trigger input TTL level(L:0 to 0.4 VDC H:3.4 to 5.0 VDC)
2. Output signal ratings
(1) Composite video (BNC, D-sub connector)
VBS 1.0 Vp-p, 75
(2) Y/C (D-sub, Y/C connectors)
Y : 1.0 Vp-p, 75
C : 0.28 Vp-p (burst), 75
(3) Component (D-sub connector)
Y : 1.0 Vp-p, 75
R-Y: 0.7 Vp-p, 75
B-Y: 0.7 Vp-p, 75
(4) RGB (D-sub connector)
R : 0.7 Vp-p, 75
G : 0.7 Vp-p, 75
B : 0.7 Vp-p, 75
(Note)
Menu settings select the D-sub connector output for Y/C, component or RGB.
(5) Sync (D-sub connector)
HD : 2 Vp-p, 75
VD : 2 Vp-p, 75
SYNC: 2 Vp-p, 75
(6) Serial data (4 pin connector)
1.5 Vp-p/ Low (in connection with RC-C10)
RS-232C level (in connection personal computer)
(Note)
Set internal switch according to connected equipment.
38
3 dB or black burst, 75
(Sync 0.3
0.1 Vp-p, burst 0.3
3 dB, high impedance (in connection with RC-C10)
0.3 Vp-p (burst), 75
or high impedance (BNC)
0.1 Vp-p)
(NTSC),
(PAL)
Advertisement
Table of Contents
