Sony SRW-1 Operation Manual page 13

TC button: Displays the TC (timecode) Setup menu (see
pages 43 to 46). This menu allows you to switch
between LTC and VITC, to switch between DF and
NDF, and to display timecode on an external monitor.
VIDEO button: Displays the VIDEO Setup menu (see
page 47). This menu allows you to make settings
related to video.
AUDIO button: Displays the AUDIO Setup menu (see
page 48). This menu allows you to make settings
related to audio.
SYSTEM button: Displays the SYSTEM Setup menu
(see pages 50 to 54). This menu allows you to make
settings related to the entire systems, such as recording
format, power, and test signal output.
See Chapter 4 "Menu Settings" (page 41) for more
information about menus.
b Display
Displays menus, audio levels, warning, operating status,
time data, remaining tape time, and remaining battery
power.
For details, see 2-1-3 "Display" (page 15).
c KEY INHI (inhibit) switch
When the KEY INHI item (see page 52) in the SYSTEM
Setup menu is set to ALL, setting this switch to ON
disables operation buttons, to prevent misoperations due to
accidental button operations.
Name Pressed alone
STOP button Stops tape transport.
Pressing this button while in standby on
mode resets the still timer.
Pressing the button while in standby off
mode puts the SRW-1 into standby on
mode.
PLAY button and Pressing the button starts playback.
indicator (The indicator lights during playback.)
To start recording, press this button
with the REC button held down.
ON: All operation buttons are disabled.
OFF: During recording, only the STOP button and
PAUSE button are enabled. All buttons are enabled
when the system is not recording.
When the KEY INHI item in the SYSTEM Setup menu is
set to MAP, the operation buttons follow the settings of the
LOCAL KEYMAP item.
d LIGHT switch
The backlight comes on when this is set to ON.
e ADJUST knob
Use to adjust audio levels, etc.
f SELECT/ENTER dial
When a menu is displayed, you can rotate this dial to move
the cursor, and press it to change and confirm settings.
g BACK button
When a menu is displayed, you can press this button to
back up one level in the menu structure.
h Control panel connection cable
Connect to the SRW-1 CTRL PANEL connector.
i Tape transport control buttons
Use these buttons for tape transport operations.
The functions of the buttons change when they are pressed
together with the FUNC button.
Pressed with FUNC button
Puts the SRW-1 into standby off mode.
Pressed with tape transport stopped: Searches for the
recording end position and stops (end search).
Pressed with recording paused: Plays back the most
recently recorded material, and then returns to recording
pause mode (recording review). When the SYSTEM
>SERVO >REC REVIEW is set to "NORM" (default
setting), one press of this button rewinds tape about 3
seconds and then starts playback. You can keep the
PLAY button pressed together with the FUNC button to
rewind tape as long as the buttons are held down (up to
a maximum of 10 seconds), and then start playback.
Recording review allows you to check whether the
material was recorded correctly.
When the SYSTEM >SERVO >REC REVIEW is set to
"ALL", one press of this button rewinds up to the
beginning of the cut recorded last and then starts
playback.
Note
REC review is not available unless at least 3 seconds have
been recorded.
(continued)
13
2-1 SRW-1