Sony SRW-1 Operation Manual page 49

Item
BEEP(PHONE) ALARM
Level of beep tones
WARN
INPUT DELAY
Settings
Determines whether to generate alarm tones.
OFF [Off]: Do not generate alarm tones.
HIGH [High]: Generate high-level alarm tones.
LOW [Low]: Generate low-level alarm tones.
Determines whether to generate warning tones.
OFF [Off]: Do not generate warning tones.
HIGH [High]: Generate high-level warning tones.
LOW [Low]: Generate low-level warning tones.
Sets the audio signal phase recorded on the tape (the target is all audio signal input).
0 [NO Delay]: No audio signal delay (use when the phase of the audio signals is the
same as the phase of the video signals).
+1F [+1F Delay]: Record audio signal with a delay of one frame (use when the video
signals of external cameras and so on are input with a delay of one frame versus
audio signals).
+2F[+2F Delay]: Record audio signal with a delay of two frames (use when the video
signals of external cameras and so on are input with a delay of two frames versus
audio signals).
+3F[+3F Delay]: Record audio signal with a delay of three frames (use when the
video signals of external cameras and so on are input with a delay of three
frames versus audio signals).
+4F[+4F Delay]: Record audio signal with a delay of four frames (use when the video
signals of external cameras and so on are input with a delay of four frames
versus audio signals).
+5F[+5F Delay]: Record audio signal with a delay of five frames (use when the video
signals of external cameras and so on are input with a delay of five frames versus
audio signals).
49
4-4 AUDIO Setup Menu