Audio Setup Menu - Sony SRW-1 Operation Manual

4-4 AUDIO Setup Menu

The AUDIO Setup menu allows you to make settings
related to audio signals.
In the Settings column of the following table:
Item
INPUT SEL
Input signal selection
PHONE SEL
MIX MODE
REC LEVEL
PB LEVEL
METER TYPE
PEAK HOLD
48
4-4 AUDIO Setup Menu
Settings
TRACK1 Selects the signal to assign to track 1.
SDI1 [SDI CH1] to SDI12 [SDI CH12], ANA1 [Analog CH1] to ANA4 [Analog CH4], A/
E7 [AES/EBU 7] to A/E10 [AES/EBU 10]
TRACK2 Selects the signal to assign to track 2.
Same settings as TRACK1 (SDI2)
TRACK3 Selects the signal to assign to track 3.
Same settings as TRACK1 (SDI3)
TRACK4 Selects the signal to assign to track 4.
Same settings as TRACK1 (SDI4)
TRACK5 Selects the signal to assign to track 5.
Same settings as TRACK1 (SDI5)
TRACK6 Selects the signal to assign to track 6.
Same settings as TRACK1 (SDI6)
TRACK7 Selects the signal to assign to track 7.
Same settings as TRACK1 (SDI7)
TRACK8 Selects the signal to assign to track 8.
Same settings as TRACK1 (SDI8)
TRACK9 Selects the signal to assign to track 9.
Same settings as TRACK1 (SDI9)
TRACK10 Selects the signal to assign to track 10.
Same settings as TRACK1 (SDI10)
TRACK11 Selects the signal to assign to track 11.
Same settings as TRACK1 (SDI11)
TRACK12 Selects the signal to assign to track 12.
Same settings as TRACK1 (SDI12)
Selects the audio signals output to the EARPHONES jack and MONITOR OUT L and
R connectors.
Selects the method of mixing audio signals output to the EARPHONES jack and the
MONITOR OUT L/R connectors.
ADD [Add]: Simple addition
RMS [RMS]: Multiplied average (root mean square)
AVG [Average]: Simple average
Adjusts the audio recording level. (This adjustment is impossible during playback.)
Adjusts the audio playback level. (This adjustment is impossible during recording.)
Sets the audio level meter display range.
PEAK [Full Peak]: Display 0 dBFS as the peak value.
REF [Full Ref]: Display the reference level (+4 dBu) as 0 dB.
FINE [Fine]: Display a scale with 0.25 dB steps centered around –20 dB.
Selects whether to use the peak hold function.
ON [On]: Use.
OFF [Off]: Do not use.
• Default settings are underlined.
• Square brackets indicate settings as displayed in setting
windows (see the figure for step 3 on page 55).