Sony SRW-1 Operation Manual page 73

To set up the Slow Shutter function
1
Perform the procedure in 6-4 "Common Settings for
Slow & Quick Motion Shooting" (page 76) to set the
target frame frequency and signal format.
2
Rotate the SELECT/ENTER dial to select "SELECT
FPS" in the submenu window.
A setting window opens.
3
Rotate the SELECT/ENTER dial to select "ON" and
press the dial.
4
Press the menu selection button "VIDEO" on the
control panel.
The VIDEO Setup menu appears.
5
Rotate the SELECT/ENTER dial to select "VIDEO I/
O" and press the dial.
A submenu window opens.
6
Rotate the SELECT/ENTER dial to select "VA
INPUT" in the submenu window.
A setting window opens.
7
Rotate the SELECT/ENTER dial to select
"CAM(Optical)" and press the dial.
8
Press the BACK button.
9
Rotate the SELECT/ENTER dial to select "CAM
TYPE".
A setting window opens.
10
Rotate the SELECT/ENTER dial to select "F950" and
press the dial.
11
Set the item "LFE" in the menu of the HDC-F950 to
"ON" and set the number of frames to store.
For details on operation of the HDC-F950, refer to the
Operation Manual of the HDC-F950.
Note
Before shooting
Every time you change the LFE and stored frames settings
on the HDC-F950, be sure to power the camera off and on
again, open the iris, and shoot a test image of a bright
subject. If you do not make a test shot, frames will not be
stored correctly and the camera will not operate correctly.
73
6-2 Slow Shutter Function