Connector Panel - Sony SRW-1 Operation Manual

2-1-4 Connector Panel

a TC IN (timecode input) connector (BNC type)
Connect to the timecode output connector of an external
device such as a timecode generator or VTR. Use this
connector when locking the internal timecode generator to
external timecode.
b CTRL (control) PANEL connector
Connect the control panel. You can remove the short cable
connected when the SRW-1 is shipped from the factory
and replace it with the supplied extension cable.
For details, see 3-1-2 "Using the Control Panel Extension
Cable" (page 25).
c EARPHONES jack (stereo minijack) and LEVEL
knob
Use this connector to attach earphones or stereo
headphones equipped with a stereo miniplug, for use in
monitoring audio during recording and playback. Adjust
the audio level with the LEVEL knob.
6 AUDIO INPUT CH-1 and CH-2 connectors and input selection switches
A warning tone is output to the earphones/headphones
when a warning is lit on the control panel display.
d TC OUT (timecode output) connector (BNC type)
Connect to the timecode input connector of an external
device such as a timecode reader or VTR.
The timecode output is determined by the setting of
OTHERS (MAIN) >TC OUT in the TC Setup menu as
follows.
TCG (timecode generator): Timecode generated by the
timecode generator is output, delayed by 1 frame.
(This maintains synchronization with the output
video).
AUTO: During recording (including E-E mode), timecode
generated by the timecode generator is output, delayed
by 1 frame. (This maintains synchronization with the
output video).
During playback, the LTC signal read from the tape is
output.
1 TC IN connector
2 CTRL PANEL connector
3 EARPHONES jack and
LEVEL knob
4 TC OUT connector
5 POWER ON/OFF switch
17
2-1 SRW-1