Sony SRW-1 Operation Manual page 33

Connections to output playback signals from this system (synchronized with SD59.94i or
SD50i)
When the frame frequency is 29.97 Hz/25 Hz, you can use
a VBS reference signal input to the REF IN SD connector
as the playback reference signal.
In the SYSTEM Setup menu, set REFERENCE >MODE
to "External," set REFERENCE >EXTERNAL to "SD"
(see page 51), and then connect as shown below.
VBS reference signal
(SD 59-94i or 50i)
In the SYSTEM Setup menu, set
REFERENCE >MODE to "External", and set
REFERENCE >EXTERNAL to "SD".
HD SDI OUT A/B
(A only, or A/B)
MONITOR OUT HD SDI
REF IN SD
MONITOR OUT SD SDI
SRW-1 + SRPC-1
Notes
• These settings are valid only when the frame frequency
of this system is 29.97 Hz/25 Hz.
• Do not connect a reference signal to the REF IN HD
connector.
• Input a VBS signal conforming to the operating frame
frequency to the REF IN SD connector.
(HD 23.98PsF)
HD SDI INPUT A/B
(A only, or A/B)
SRW-5000 HD Digital Videocassette
Recorder
HD monitor
SD monitor
3-3 About Reference Sync Signals
33