Table of Contents
Advertisement
Location and Functions of Controls
Connector Panel
1
CH-1
CH-2
ANALOG IN
CH-1
CH-2
ANALOG OUT
CH-3
CH-4
ANALOG OUT
4
5
The illustration shows the DRE-S777 with the optional DABK-S701 and two DABK-S702 installed.
1 ANALOG I N connectors (XLR type)
By installing the optional DABK-S701 A/D converter,
channel 1 (CH 1) and channel 2 (CH 2) analog inputs
are provided. The DABK-S701 is equipped with the
XLR-3-31 type connectors.
The DABK-S701 is equipped with a 600 ohm/high
impedance selector and a +4 dBm/0 dBm input gain
selector on its board.
2 DIGITAL input/output connectors (XLR type)
These digital input/output connectors are equipped as
standard.
One channel for digital input (IN) and two channels for
digital outputs (OUT) are provided.
IN is a XLR-3-31 type connector and OUT 1 and OUT
2 are XLR-3-32 type connectors.
The OUT 2 connector functions only when the
optional DABK-S703 expansion DSP is installed.
3 Ground terminal
Connect to the ground line.
2
IN
OUT1
OUT2
DIGITAL
IN
OUT
WORD SYNC
MIDI
RS-232C
IN
OUT/THR
6
7
8
4 ANALOG OUT connectors (XLR type)
By installing the optional DABK-S702 D/A converter,
channel 1 (CH 1) and channel 2 (CH 2) analog outputs
are provided. The DABK-S702 is equipped with the
XLR-3-32 type connectors.
The DABK-S702 is equipped with a +4 dBm/0 dBm
output gain selector on its board.
5 ANALOG OUT connectors (XLR type)
By installing the optional DABK-S702 D/A converter,
channel 3 (CH 3) and channel 4 (CH 4) analog outputs
are provided. The DABK-S702 is equipped with the
XLR-3-32 type connectors.
6 WORD SYNC connectors (BNC)
IN: Inputs the word sync signal. A 75-ohm terminator
is installed.
OUT: Outputs the word sync signal (regeneration
output signal).
Note
The word sync signal is output only when the input
connector of the destination equipment is terminated at
75 ohms.
3
9
(continued)
11
Chapter 1 Overview
Hide quick links:
Advertisement
Table of Contents
