System Status - ZyXEL Communications Prestige 642 User Manual

Prestige 642 ADSL Internet Access Router

10.1 System Status

The first selection, System Status, gives you information on the status and statistics of the ports, as shown
below. System Status is a tool that can be used to monitor your Prestige. Specifically, it gives you
information on your ADSL line status, number of packets sent and received.
To get to the System Status, enter number 24 to go to Menu 24 - System Maintenance. From this menu,
select number 1, System Status. There are two commands in Menu 24.1 - System Maintenance -
Status. Entering 1 resets the counters and ESC takes you back to the previous screen.
The table below describes the fields present in Menu 24.1 - System Maintenance - Status. It should be
noted that these fields are READ-ONLY and are meant to be used for diagnostic purposes.
Please note that displaying this screen degrades system performance.
Node-Lnk Status
1-1483 Up
2 N/A
3 N/A
4 N/A
5 N/A
6 N/A
7 N/A
8 N/A
Ethernet:
Status: 100M/Full Duplex
Collisions: 0
CPU Load = 4.25%
Figure 10-2
The following table describes the fields present in Menu 24.1 - System Maintenance - Status.
10-2
Menu 24.1 -- System Maintenance – Status
TxPkts RxPkts Errors
1462 1567
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Tx Pkts: 1583
Rx Pkts: 1521
Press Command:
CMDS: 1-Reset Counters
Menu 24.1 - System Maintenance – Status
Tx B/s Rx B/s
0 222 211
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
WAN:
Line Status: Up
Upstream Speed: 608 kbps
Downstream Speed: 4000 kbps
ESC-Exit
Up Time
2:15:16
0:00:00
0:00:00
0:00:00
0:00:00
0:00:00
0:00:00
0:00:00
System Maintenance